Community Profile

photo

Pooja


Active since 2013

Research Scholar
Professional Interests: Wireless Communication, Automatic Control

Statistics

  • Thankful Level 1

View badges

Content Feed

View by

Question


Regarding configuremodelsim, It does not configure the selected modelsim
Hello, For HDL Co-simulation in MATLAB 2011a, I have two modelsim installed on my machine 1)Modelsim XE 6.2c and then I insta...

10 years ago | 3 answers | 1

3

answers

Question


Error while running FIL Wizard for Atlys Spartan 6 kit.
Hello, I am using MATLAB r2011a, I am able to program FPGA with the FIL Wizard, but when I try to run the model, it shows fol...

10 years ago | 1 answer | 0

1

answer

Question


Error in S-function while running FPGA-in-the-loop, FIL Wizard
Am using MATLAB r2011a, I have made simulink model and using FIL wizard for Atlys Spartan 6 kit. Am successfully able to gener...

10 years ago | 1 answer | 0

1

answer

Question


Simulink block for switching: Multiport switch block not supported in HDL Coder
Hello, I am using Matlab 2011a. In simulink when i use Multiport Switch block, the HDL Compatibility test gives following Error...

10 years ago | 1 answer | 0

1

answer

Answered
I am using MATLAB R2011a, am getting error in HDL workflow advisor Set target interface, FPGA pin specification.
Hi Tim, Thanks for your response. I tried specifying pin numbers as {'1', '2', '3', '4', '5', '6', '7', '8', '9', '10', '11'...

10 years ago | 0

| accepted

Question


I am using MATLAB R2011a, am getting error in HDL workflow advisor Set target interface, FPGA pin specification.
I have selected Atlys Spartan 6 development board. In Set target interface, when i am specifying interface as "Specify FPGA Pin...

10 years ago | 2 answers | 0

2

answers