Community Profile

photo

Noor Amira Ilyanie


Last seen: 15 days ago Active since 2022

Statistics

  • Thankful Level 2
  • First Answer

View badges

Content Feed

View by

Question


When I run the simulation, I am facing this problem.
Build process completed successfully Saving external mode simulation output as a single object is not supported because the wor...

2 months ago | 1 answer | 0

1

answer

Question


Simulation on MPU6050 Accelerometer using simulink block. Why I end up getting the data start from zero for acceleration z-axis when I include the filter?
This is my simulink model. I observed that my data when i run the simulation it start from zero. It should start within 9.81 val...

2 months ago | 0 answers | 0

0

answers

Question


WHY IS IT WHEN I RUN THE MODEL, IT IS INVALID AND SHOW ERROR.
I keep getting this error when i run the model "Error in port widths or dimensions. 'Output Port 1' of 'dcmotornew260822/MPU6050...

3 months ago | 1 answer | 0

1

answer

Question


mpu6050 calibrations, offset of the mpu6050 and filtering noise.
I got the raw data from the accelerometer mpu6050 in simulink matlab. the blue data is x, red is for y and orange is for z axis ...

3 months ago | 0 answers | 0

0

answers

Question


Problem in getting the data stored to SD card after running the hardware test using Arduino mega that are attached with mpu6050 accelerometer and also SD card.
I have the simulink model of dc motor that are connected to arduino with the attachment of mpu6050 accelerometer and also sd car...

3 months ago | 1 answer | 0

1

answer

0

answers

Answered
DC Motor Position Control using Potentiometer as a Feedback
what is 0 to 255 unit? is it voltage or rpm? or bit?

4 months ago | 0

Question


Can I read voltage and current measurement from simulink model that containts a model of connections in Arduino Uno?
I had done the connections on simulink for the attachment of the pins in Arduino to the dc motor. But i dont know how to take th...

4 months ago | 1 answer | 0

1

answer