peter

Last seen: 2 months ago | Active since 2024

Followers: 0 Following: 0

Statistics

Feeds

Question

What types of components should be connected to the interfaces of the fault(three-phase) module?
What components should be connected to the external trigger of the faulty (three-phase) module? I think it should be input contr...

2 months ago | 1 answer | 0

1

answer

Question

Remogenerate optimized code by removing code for out-of-range floating point to integer conversions did not improve execution speed，is there a problem?
I want to improve the running speed of the code converted from Simulink to C coder, so I tried setting the maximum running speed...

3 months ago | 1 answer | 0

1

answer

Question

How to improve the running speed after converting to code by setting the properties in the Simulink model?
After using the C coder to convert the model, I hope that the code can run as quickly as possible without affecting its function...

4 months ago | 1 answer | 0

1

answer

Question

Why does the debux module generate an error message 'Signal name' signal 'doesn't match with the signal name' vabc1 'specified at port' 1 '？
I want to separate the three-phase signals because I want to obtain each phase signal separately, but there are several issues w...

4 months ago | 2 answers | 0

2

answers

Question

What principles does the accumulator for storing data (output or intermediate) follow after converting the model into C code using a C coder?
For example, is the upper limit of i in the for loop automatically generated based on factors such as the size of the data or so...

4 months ago | 1 answer | 0

1

answer

Question

How to control the generation of fixed points within a fixed period of 1ms and gradually generate points (waveforms) according to the progress of the period (time)？
I generated the code for the model using a C coder, and for real-time performance, I want to push it forward every 1ms. During t...

4 months ago | 1 answer | 0

1

answer

Question

During the installation process of the support package, it was displayed that the system did not start the MATLAB version required for the installation of the support package.
After downloading the support package offline, I found that the install_spportsoftwareexe mentioned in the readme document does ...

5 months ago | 1 answer | 0

1

answer