photo

David Amor


Active since 2013

Followers: 0   Following: 0

Message

Statistics

All
  • First Review
  • Thankful Level 1
  • Revival Level 1
  • Knowledgeable Level 1
  • First Answer
  • Promoter
  • Commenter
  • Solver

View badges

Feeds

View by

Answered
Relationship Between Simulink and FPGA Clock
In the "Model Configuration Parameters" (the cog at the top) Set your solver to "Fixed-step" and "Discrete (no continuous states...

7 years ago | 0

| accepted

Answered
Rapid Accelerator - Monte Carlo simulation
Two steps: (1) Add 'SaveState','on' To the input parameters of "sim" such that the states of the system will be logg...

9 years ago | 1

| accepted

Question


Rapid Accelerator - Monte Carlo simulation
I followed the instructions on this <http://blogs.mathworks.com/seth/2015/03/19/getting-the-most-out-of-rapid-accelerator-mode b...

9 years ago | 1 answer | 0

1

answer

Answered
Help with 'Make Error' in Simulink
Have you tried putting the project in a directory lower down in the C: drive e.g. move C:\Users\Ian\Documents\School\D+C ...

10 years ago | 0

Answered
Simulink block to extract signal at index from vector signal doesn't exist?
Are you trying to get a single bit from a vector at an index? If so bitget would be easier and less verbose. ans = bitget(...

10 years ago | 0

Question


generating a repeating (Digital) sequence in simulink
Hello All, I need to generate a digital signal that repeats (signal is based on an RS232 signal), I have tried using the "Rep...

10 years ago | 0 answers | 0

0

answers

Question


simulink mxArray subscripting not supported
Hello all, When I try this: disp(VariableNames(i)) I get an error: Subscripting into an mxArray is not supported. ...

11 years ago | 0 answers | 0

0

answers

Answered
How do I change the default Matlab editor into Notepad++?
I am getting the same. I think this is a genuine bug... There are other bugs with the editor in 2013b release (the breakpoi...

11 years ago | 0

Answered
Embedded matlab block as a parameter - not an input (without "ports and data manager")
sorry, I just found this: coder.extrinsic('evalin') fixed_step_size = evalin('base', 'fixed_step_size'); Dave

11 years ago | 0

| accepted

Question


Embedded matlab block as a parameter - not an input (without "ports and data manager")
Hello, When using an embedded Matlab block within Simulink, I would like to make the use of parameters more transparent by in...

11 years ago | 1 answer | 0

1

answer

Question


HDL Code generation - exclusion of code
Is there a way to exclude "Embedded Matlab blocks" in Simulink from code generation Illegal "Embedded Matlab" code generation...

11 years ago | 1 answer | 0

1

answer