Design Optimization™ software supports
simulation modes. You can accelerate the design optimization computations by changing the
simulation mode of your Simulink model to
Accelerator. For information about these modes,
see How Acceleration Modes Work.
The default simulation mode is
this mode, Simulink uses interpreted code, rather than compiled
C code during simulations.
Accelerator mode, Simulink
Design Optimization software
runs simulations during optimization with compiled C code. Using compiled
C code speeds up the simulations and reduces the time to optimize
the model response signals.
If the model structure changes during optimization, the model is compiled to
regenerate the C code for each iteration. In this case, using the
Accelerator mode increases the computation time. To learn
more about code regeneration, see Code Regeneration in Accelerated Models.
To set the simulation mode to
Accelerator, open the Simulink model window and perform one of the following actions:
Under Simulation, choose
Accelerator from the drop-down list as shown
in the next figure.
To obtain the maximum performance from the
Accelerator mode, close all Scope blocks in