How to make input in degree value with dwell time ?
4 views (last 30 days)
Show older comments
KRISHAN THILAKARATHNE
on 10 May 2022
Commented: Heshan Manu
on 19 May 2022
How to make the following statement in simulink ?
"enter a step move of 270 deg of the rotor, a dwell time of 8 seconds anda return step move"
Is this make from 'Step input', 'Sine wave' or other way ?
3 Comments
Joel Van Sickel
on 19 May 2022
Edited: Joel Van Sickel
on 19 May 2022
yes, use this block and create a second one and subtract/add them together to create 2 transitions.
Accepted Answer
Joel Van Sickel
on 18 May 2022
Edited: Joel Van Sickel
on 18 May 2022
Hello Rishan,
this is a fairly complicated question depending how far you have to take it. If you want to create a Simulink model that is just a value that is 0, then goes to 270, and then back to 0 after 8 seconds, you can use a source block to create that.
To do it more complicated would require using some sort of timer. An integrator with an input value of 1 is an easy to implement a timer in Simulink. When it's output is 8, 8 seconds have passed. You can also reset the integrator once your reached the relevant time. However, if you need to make an actual motor move, you have to then translate that command to actual motor commands, which is very dependent on what type of motor you are using.
Regards,
Joel
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!